GTS Technical Manual
9. April 2021 Edition: V1.00/2021 5-7
Copyright © 2020, Diversey
05.70.17 tank - vacuum motor - 3500µicro_V1.00.fm
• Build in and position the vacuum motor assembly.
• Mount the four fixation screws from the inner side of the tank.
• Place the inlet protection plate and mount the 4 screws.
• Place the filter cloth together with the holding frame.
• Close the tank cover.
• Position the connection support plate and mount the two screws.
• Connect the vacuum motor wires to the connection block.
• Mount the seat cover according to chapter MOUNTING OF
• DRIVER SEAT COVER.
Remarks
If you have to remove cable ties then position the new ones at the
original place.
To Next Page
Loading...
