TechnipFMC Sening MultiFlow - Page 13

MN F09 002 US  DOK-383E  Issue/Rev. 3.65 (02/24)
MultiFlow  General
Sening
®
is a registered trademark of FMC Technologies
19
 After setting these 8 parameters the system is ready for calibration. Set
the calculated meter factor for each product under parameter
3.5.1.X.7.5.1. The placeholder X stands for the product number. (1=
Heating Oil / 2 = Diesel etc.). For further information, please compare
chapter 9.10 "Product Registers (35nn..)" / page 166.
 For details and further information please use chapter 3 "General
Installation Instructions" / page 31.