TechnipFMC Sening MultiFlow - Carrying out a Discharge (Part 3)

MN F09 002 US  DOK-383E  Issue/Rev. 3.65 (02/24)
MultiFlow  Discharge
Sening
®
is a registered trademark of FMC Technologies
79
☺ After you have pressed the <Start> key, the defined / allowed discharge
passes will be displayed first:
 Select the discharge pass by pressing <F1> or <F2> and press the
<Enter> key to confirm your selection.
 You can also select the discharge pass by entering the
corresponding number.
If only a single position is transferred, this is automatically
selected with no intervention by the operator required (from
program version 3.00 and higher)
6.5 Carrying Out a Discharge (Part 3)
 Step 3: Press the <Start> key.
☺ The discharging operation is
started. The delivery screen is
displayed.
☺ Delivery is started.
 In combination with a GPS
enabled EMIS the current
GPS coordinates are
determined at the beginning
of the discharge and stored in
the logbook. These can later
be printed in the event report.
Del iv er y
H ea ti ng
Pr es et : 5 50 0 L
-- -- -- -- -- -- -- --- --
150
C om pe ns at ed
t o 15 °C


-- -- -- -- -- -- -- --- --
R em ai n
7: 40 mi n
Av er ag e
V T
V1 5
+1 5,8 ° C
32 . 0 l
3 2.5 l
- --
- -- >>