With liquid products the price normally refers to 100 litres, so the unit
"litres" and the factor "100" must be selected.
The price factor is accepted into the MultiFlow with <Print>.
Finally, the tax rate must be defined.
Here the tax rate applicable to the product is entered.
The tax rate is accepted into the MultiFlow with <Print>.
7.3 Product restrictions
Since metering equipment is usually specific to certain product groups,
some of the products installed in the factory settings need to be
restricted.
Deactivated (restricted) products do not appear on a print-out of the
parameter list and also cannot be selected by the operator for a
discharge. No calibration of these products is therefore required!
Number of Selection Window →
Product Description →
Function Key Assignment →
In order to bar the product heating oil+ first select the parameter index
3.5.1.9. Press key <2> to access the type of product.
To Next Page
Loading...
