TechnipFMC Sening MultiFlow - Categories of Parameters

Sening
®
is a registered trademark of FMC Technologies
297
MN F09 002 US  DOK-383E  Issue/Rev. 3.65 (02/24)
MultiFlow  Address and contact details
Appendix B. Parameter summary
Display Configuration / Device Settings
No.
Name
Seal
K
1
Factory
Setting
Meaning
1
Display Config.
1.1
Contrast
D
x
Display contrast setting
1.2
Date and Time
M/
Cal
0/x
Sets internal clock
IMPORTANT:
Date is subject to W & M restrictions!
1.3
User's Language
D
x
Display language for menus, alarms and reports
1.4
Customer's Lang.
D
x
Display language for deliveries and receipts
No.
Name
Seal
K
1
Factory
Setting
Meaning
2
Grand Totals
D
0/x
–
Display of grand totals
Long-term and shift counters:
• Sum of uncompensated volume in liters (V
0
)
• Sum of compensated volume in liters (V
T
)
•
Sum of masses in kg
•
Sum of measured additive in liters
NOTE: The day / shift counter can be reset with
function key F1.
No.
Name
Seal
K
1
Factory
Setting
Meaning
3
Parameter List
3.1.1
Device Number
Cal.
1
-
This parameter should be assigned the device ID
(name-plate, see housing of operating device).
3.1.2
Meter Designation
Cal.
1
-
This parameter is used for identifying the measuring
system. The designation is printed on all delivery
notes and reports.
Recommendation:
Use the serial number of the measuring chamber
(name-plate).
3.1.3
Seal Password
Cal.
1
123456
Password protection for electronic W & M seal.
Categories Of Parameters
K
Priority
Meaning
0
Cal., EEPROM
Highest security level;
device settings which are not saved on the parameter chip
1
Cal.
High security level due to additional checksum;
parameter transfer from the chip card only possible when seal is
broken !
2
Master
High security level due to additional checksum;
parameter transfer from the chip card only possible when seal is
broken !
3
Master
Medium security level
x
Driver
Lowest security level; parameters which are not saved on the chip
card