Once the desired code is entered, the preset discharge quantity and
default price are displayed marked by pointed brackets (> XX <). By
pressing the <Enter>-key you can confirm these settings. For
verification the input value is displayed in double size characters at the
bottom of the display area (underneath the status line). With the
numerical keys you can change these entries. The <Enter>-key
confirms the input and switches to the next input field.
6.3 Measuring system residue removal (optional)
Now you have selected the desired product. Continue with part 3 of the
discharging operation (chapter 6.5 "Carrying Out a Discharge (Part 3)" /
page 79 ).
Step 2: Press the <Start> key.
When using the “device for emptying and refilling the measuring system”
according to Authorization 5.162 / 01.01 the operator is asked during a
product change whether the necessary emptying/refilling has been
carried out.
If this is answered with ’YES’ a corresponding entry is written into the
logbook and the delivery dialog – start of delivery is continued. If
answered with ’NO’ then a message appears with the request to carry out
the residue removal / refilling and a corresponding entry is made in the
logbook.
6.3.1
MultiFlow up to version 5.00
The measuring system residue removal message can be switched on
and off with parameter 3.1.8.5.1. In addition parameter 3.1.8.5.2 has
already been implemented which in a future version will activate the
printing out of a document concerning successful residue removal.
If parameter 3.1.8.5.1 (residue removal control) is set to 1, this causes
the following new operating sequence:
To Next Page
Loading...
