TechnipFMC Sening MultiFlow - Receipt ID; Printer Settings

MN F09 002 US  DOK-383E  Issue/Rev. 3.65 (02/24)
MultiFlow  Address and contact details
Sening
®
is a registered trademark of FMC Technologies
307
Receipt ID
No.
Name
Seal
K
Factory
Setting
Meaning
3.1.9
Receipt number
3.1.9.1
Separate receipt
number
Cal.
0
0 (no)
0: Joint numbering cycle for delivery note and
invoice numbers
1: Separate delivery note and invoice numbers
3.1.9.2
Receipt number (*)
Cal.
0
0
Number to be used for next receipt
3.1.9.3
Invoice no. (*)
Cal.
0
0
Number to be used for next invoice
3.1.9.4
Delivery note no. (*)
Cal.
0
0
Number to be used for next delivery note
(*): - Depending on the parameter setting 3.1.9.1 either parameter 3.1.9.2 or parameters
3.1.9.3 and 3.1.9.4 are shown.
Printer Settings
No.
Name
Seal
K
Factory
Setting
Meaning
3.2
Printer
M
3.2.1
Printer Selection
1:M
2:M
3:M
4:M
5:M
6:M
7:M
8: M
9:Cal.
3
7 (TM-U295)
Printer selection
1: Dr-570
2: DR-290/295 (FDW)
3: DR-298 (FDW)
4: FX (Tally)
5: ASCII
6: TM-U220
7: TM-U295
8: BLASTER ADV. (only MID-Version)
9: No printer
(this function is not available in some countries)
3.2.2
Interface Type
M
3
0 (RS232)
Switch between RS232 and RS485.
3.2.3
Transfer Rate
M
3
0 (9600
baud)
Data transmission speed.
3.2.4
Parity Check
M
3
0 (none)
Activation / deactivation of the parity check.
0: No parity
1: Even Parity
2: Odd parity
3.2.5
Lines per Page
M
3
57
Number of lines on a page.
3.2.6
FDW protocol
3.2.6.1
Protocol
Cal.
1
1 (yes)
Activation / deactivation of the FDW protocol for data
subject to W & M restrictions.
3.2.6.2
FDW timeout
M
3
5 (sec)
Max. waiting period for FDW status interrogation.
3.2.6.3
Resends
M
3
2
Number of repeated transmissions when erroneous
transmissions occur.
3.2.6.4
Max. error count
Cal.
1
99
Sets the number of erroneous printouts (unsuccessful
attempts to print a receipt correctly) which are allowed
before the device blocks any further discharges.
NOTE: Function currently not supported
3.2.7
Paper feed
M
3
1 (autom.)
Activates the automatic paper feed when using the
DR-295.
3.2.8
Reverse ejection
M
3
0 (no)
Enables the reversal of the paper ejection direction
for DR-295- and DR-298 printers.
2 no, ejection opposite to printing direction (i.e.
“forwards”)
1 yes, ejection in the printing direction (i.e.
“backwards”)
3.2.9
Data bits
M
3
1 (8bit)
Number of data bits for data transfer
0: 7bits
1: 8bits