TechnipFMC Sening MultiFlow - TALLY Printer MIP 480 - Settings and Parameterization

Sening
®
is a registered trademark of FMC Technologies
261
MN F09 002 US  DOK-383E  Issue/Rev. 3.65 (02/24)
MultiFlow  Miscellaneous Information
 Settings of the MultiFlow.
No.
Name
Setting
Meaning
3.2.1
Printer Selection
7
7: TM-U295
3.2.2
Interface Type
0
RS232
3.2.3
Transfer Rate
0
9600 baud
3.2.4
Parity Check
1
1: Even Parity
3.2.5
Lines per Page
57
Number of lines on a page
3.2.6.1
Protocol
0
FDW protocol inactive
3.2.9
Data bits
1
1: 8bits
14.7 TALLY printer MIP 480 – Settings and
parameterization
The TALLY printer menus and functions are not shown on a display but
printed out as guides. These print-outs are controlled by the commands
listed beneath the printer keys <NEXT> <PREVIOUS> <ALT> and
<SETUP/EXIT>.
 Connect the printer to the power supply using
a 10 A cable with a width of at least 1,5 mm²
and secure the connection.
Important !
Do not connect the printer to the MF-
EPS !
 Open the printer cover first; otherwise the
printed text will not be visible.
14.7.1 Printer keys
 Please first print out the preselected setup-values in order to get an
overview of the settings before parameterizing the printer. The most
important parameters in this case are: