TechnipFMC Sening MultiFlow - Page 256

260
Sening® is a registered trademark of FMC Technologies
MN F09 002 US  DOK-383E  Issue/Rev. 3.65 (02/24)
MultiFlow  Miscellaneous Information
 Settings to the MultiFlow:
Menu option
Value to be entered
Meaning
3.2.1
Printer selection
7
TM-U295
3.2.6.1
LDT protocol
0
OFF
3.2.4
Parity check
1
Even parity
14.6.2 MultiFlow versions from V3.49
 For MultiFlow versions with a separate option to set the number of data
bits set the data format to 8E1 as follows. This allows the use of special
characters even in secure data transfer.
 The printer is factory-set for connection to the Multi-Flow.
 No further adjustments need to be made to the printer.
 The following factory settings are to be checked on the printer in the
event of a fault. The switches to set the operating mode of the TM-U295
are located on the bottom of the unit.
 The following factory settings are to be checked at the printer:
 Make the following settings to the MultiFlow before setting the electronic
seal in order to operate the TM-U295 correctly (without FDW converter).
These are available from the SW Version 3:49 [3:49] DE and allow the
use of special characters, even with secure data transmission.
DSW1
Position
Function
1
OFF
Transfer error:
“?“ print
2
OFF
512 byte data buffer
3
ON
Handshake XON/XOFF
4
OFF
8 bits
5
ON
Parity used
6
ON
Even parity
7
OFF
9600 baud
8
OFF
9
OFF
No pin 6: Reset signal
10
OFF
No pin 25: Reset signal