TechnipFMC Sening MultiFlow - Electronic Seal; Calibration; Diagnosis; Initialize

MN F09 002 US  DOK-383E  Issue/Rev. 3.65 (02/24)
MultiFlow  Address and contact details
314
Sening® is a registered trademark of FMC Technologies
Electronic Seal
No.
Name
Seal
K
Factory
Setting
Meaning
4.1
Electronic seal
4.1.1
Display Seal
D
Display status of electronic W & M seal.
4.1.2
Print Seal
D
Print status of electronic W & M seal.
4.1.3
Break Seal
M/
Cal.
Breaks the electronic W & M seal to obtain access to
sealed parameters.
ATTENTION: This function is not available in some
countries
4.1.4
Restore Seal
M/
Cal.
Saves modified W & M information.
IMPORTANT: To be executed in the presence of a
W & M inspector or service person
only!
Calibration
No.
Name
Seal
K
Factory
Setting
Meaning
4.2
Calibration
Cal.
Procedure for measuring the meter factors at
various flow rates.
Diagnosis
No.
Name
Seal
K
Factory
Setting
Meaning
4.3
Diagnosis
4.3.1
In- / Outputs
M/Cal.
Tests the inputs and outputs.
IMPORTANT: The setting of the outputs is subject
to W & M restrictions!
4.3.2
Printer
M
Loop-back test for testing the printer line with a
special printer connector.
4.3.3
Global CAN Bus
M
Display link status of all CAN Bus devices.
4.3.4
Remote control
M
Testing the radio remote control
4.3.5
---
4.3.6
EPE2
M
(version 5.00 and higher)
Testing the EPE2 functions
4.3.7
IO interface
M/Cal.
Testing the external inputs and outputs of the IO
module (8 outputs, 2 inputs).
4.3.8
Sensor interface
M
Checking the statuses of the activated sensor inputs
of the external sensor module.
4.3.9
TMC test
To test the TMC telegrams. N/A.
Initialize
No.
Name
Seal
K
Factory
Setting
Meaning
4.4
Initialize
M/Cal.
Resets the device parameters (restores the
factory settings).
4.4.1
Device Parameter
M/Cal.
(version 5.02 and higher)
Resets the device parameters