TechnipFMC Sening MultiFlow - 11 Printing out Reports

218
Sening® is a registered trademark of FMC Technologies
MN F09 002 US  DOK-383E  Issue/Rev. 3.65 (02/24)
MultiFlow  Printing out Reports
11 Printing out Reports
 Each delivery is saved by the
MultiFlow and can be printed
out later as a report. Thus a
complete shift or tour can be
documented with all the events
occurring on a tour or trip
teport.
 In order to activate the print
menu press the <Print> key in
the ready menu on the
MultiFlow.
 With the reports menu which is
then displayed you can select
and print all the required reports.
The following reports can be called with the <Print> key:
No.
Name
Seal
K
Factory
setting
Meaning
1
Short report
D
Short report over the selected reporting period.
Selection possible according to time or receipt no.
2
Detailed report
D
Detailed overview over the selected reporting period.
Selection possible according to time or receipt no.
3
Copy receipt
D
Reproduction of receipts according to selected receipt
numbers
4
ZERO receipt
D
Receipt as proof that counter is at ZERO
5
Parameter list
D
5.1
W & M settings
D
Only prints settings relevant to W&M requirements
5.2
All settings
D
Prints all settings.
5.3
Driver list
M
Output list of all registered drivers
NOTE: The passwords for the master access are
printed as well.
5.4
Form elements
D
Listing of defined form elements
5.5
Receipt layout
D
Test printout of defined receipt layout
6
Event report
M
Print extract from the log book according to
selected time period
7
Office link
F
Save a trip report on the chip card
7.1
Chip card
F
Saving a trip report to a chip card.
7.2
Office transfer
F
7.2.1
Delivery data
F
Only available in combination with an EMIS. Transfer
of delivery data to the EMIS. Selection can be made
according to time or receipt number.
7.2.2
Event data
F
Only available in combination with an EMIS. Transfer
of selected event data to the EMIS. Selection can be
time-related.
7.2.3
Sensor monitoring
F
Only available in combination with an EMIS. Transfer
of selected sensor-specific data to the EMIS.
Selection can be time-related.
8
Reserved
9
Reserved
Re p or ts
Sel ec ti on :
1 Sh or t Re po rt
2 De ta il ed R ep ort
3 Co py R ec ei pt
4 Ze ro - Bi ll
5 Pa ra me te r Li st
6 Ev en t Re po rt
7 O ff ic e Li nk
8 ( -- - )
9 ( -- - )
0 Ot he r
Up Do wn ---