TechnipFMC Sening MultiFlow - Extended Product Definition

244
Sening® is a registered trademark of FMC Technologies
MN F09 002 US  DOK-383E  Issue/Rev. 3.65 (02/24)
MultiFlow  Error messages and status information
12.1 Extended product definition
Product register (3.5.n.n.6.4)
The placeholder 'n.n' in the product register corresponds to the
product register number, where 'n.n' varies from 11 to 30. To clearly
identify a parameter in a product register, the product register number
is expanded to include the parameter number.
In order to be able to fulfill the information required by the
CO2KostAufG, further product-specific specifications are required.
These are summarized in the respective product definition under
parameter 3.5.n.n.6.4.
Nr.
Name
Seal
K
Factory Setting
Decription
3.5.n
Product Page
3.5.nn.6
Default Price
3.5.n.n.6.4
CO2 Costs
M
3
Definition according to German CO2 Cost
Allocation law
3.5.n.n.6.4.1
Enable
M
3
1
General (de)activation of optional info on the
receipt
3.5.n.n.6.4.2
Caloric value
M
3
42,8 GJ/t 1)
Calorific value in [GJ/t]
3.5.n.n.6.4.3
Emission factor
M
3
0,074 CO2/GJ 1)
Calorific value-related emission factor in
[tCO2/GJ]
3.5.n.n.6.4.4
Certificat costs
M
3
30 1)
Price per emission certificate
3.5.n.n.6.4.5
CO2CostInfo
M
3
1 1)
(De)Activation of the reference to the
reimbursement claims regulated in Section 6 §2
and Section 8 §2.
1) The values stated apply to the factory setting of the standard product
“Heating oil EL” in the “DE” language version of the MultiFlow software.
For all other products and language variants, the factory setting of the
listed product parameters is '0'.
Using parameter 3.5.nn.6.4.1, the expenses required according to
CO2KostAufG can be activated on a product-specific basis. Since
they are only required when delivering fuel to generate heat, this
parameter is deactivated by default, with the exception of the product
“Heizoel EL” in the “DE” language version.
The units of the parameters 3.5.nn.6.4.2 and 3.5.nn.6.4.3 correspond
to the requirements of the Emissions Reporting Ordinance 2022
(EBeV 2022).
The price per emission certificate is defined via parameter
3.5.nn.6.4.4. This price will continue to increase over the next few
years. When entering information, please pay attention to the current
legal requirements.
The parameter 3.5.nn.6.4.5 is used to optionally activate the printout
of the required reference to the reimbursement claims regulated in the