TechnipFMC Sening MultiFlow - Page 241

Sening
®
is a registered trademark of FMC Technologies
245
MN F09 002 US  DOK-383E  Issue/Rev. 3.65 (02/24)
MultiFlow  Error messages and status information
CO2KostAufG. Deactivation reduces the space required by the form
module “CO2KostAufG. Block” on the printout by 2 lines and is
intended for customers whose forms already contain this information.
Layout element “CO2KostAufG. Block“
The expenses required according to the CO2KostAufG are
summarized in a form module.
ID
Output
Name
Remarks
39
Delivery CO2 emission data:
Emission : XXXX,XXX kgCO2
Emissions costs : YY,YY EUR
Emission factor : X,XXXX kgCO2/kWh
Caloric value : XXXX,XX kWh
Claims due to self-sufficiency according
to par.6(2)&8(2)CO2KostAufG possible
CO2KostAufG.
Printout of the CO2 emission data
NOTE: Regardless of the options specified, the form module
“CO2KostAufG” is printed out. Block” is always compressed due to the
increased space required!
NOTE: The amount specified under “Price component” is
based on the price per emission certificate specified in the product
definition (3.5.nn.6.4.4) plus the tax rate specified in the product
definition (3.5.nn.6.3).
NOTE: By default, the form module “CO2KostAufG” is printed
out. Block” only on invoices for private individuals. If the customer type
query (3.1.4.5.4) is deactivated, make sure that the “Invoicing”
parameter (3.1.4.0.1) is set to “1 (gross)”.
NOTE: By default, the form module “CO2KostAufG” is printed
out. Block” only on invoices for private individuals. Using the “Options”
of the form module, it is also possible to output them on all printouts
(““‘), delivery notes (“L“‘) or also on commercial invoices (“RR”).