TechnipFMC Sening MultiFlow - DIL Switch Settings of TM-U220

258
Sening® is a registered trademark of FMC Technologies
MN F09 002 US  DOK-383E  Issue/Rev. 3.65 (02/24)
MultiFlow  Miscellaneous Information
15.4 DIL Switch Settings of TM-U220
The switches that determine the operating mode of the TM-U220 are
located behind the flap at the bottom of the device (see manual).
 The following factory settings are to be checked on the printer in the
event of a fault:
DSW2
Position
Function
1
ON
42/35 characters / line
2
OFF
Autocutter
3
OFF
- - -
4
OFF
Serial interface activated with
DIP switch
5
OFF
- - -
6
OFF
Overwriting of flash memory
inactive
7
OFF
Pin 6 Reset inactive
8
ON
Pin 25 Reset inactive
DSW1
Position
Function
1
OFF
Transmission error:
Print “?“
2
ON
40 Byte data buffer
3
ON
Handshake XON/XOFF
4
OFF
8 Bit
5
OFF
No parity
6
OFF
Uneven parity
7
OFF
9600 Baud
8
ON
Busy:
Buffer full & offline