6 Discharge
Usually the discharge of product proceeds as follows:
1.
Switch on the MultiFlow
2.
Start discharge
3.
Select product (or accept preset)
4.
Select discharge path (*
5.
Discharge
6.
Terminate discharge (and/or deliver additive)
7.
Print delivery note or bill
Single steps can be enabled / disabled by changing the setup.
*)
optional:
In versions lower than 3.10 the discharge path is selected prior to the
product, in versions lower than 2.0 selection of the discharge path is not
included.
6.1 Carrying Out a Discharge (Part 1)
After being switched on, the MultiFlow runs a self-test after which it is
ready for discharge.
Start screen
Step 1:
Press the <Start> key.
To Next Page
Loading...
