TechnipFMC Sening MultiFlow - Product Registers (35 Nn; Driver List; Driver Register (36 N

MN F09 002 US  DOK-383E  Issue/Rev. 3.65 (02/24)
MultiFlow  Address and contact details
Sening
®
is a registered trademark of FMC Technologies
313
No.
Name
Seal
K
Factory
Setting
Meaning
3.5.nn.7.7.3
Change factor
Cal.
1
0
Density change factor to calculate according to
"Method 1" in [1 / K]
-1000.0 1000.0 ...,
Minimum value: + /-1.0E-7
3.5.nn.8
Hose set
M
2
WP
Allowed hoses for this product, see parameter
3.1.8.7
Driver List
No.
Name
Seal
K
Factory
Setting
Meaning
3.6
Driver list
3.6.1
Driver 1
M
Driver Register 1 (entry of the driver's ID and name
and of the master code)
3.6.2
Driver 2
M
Driver Register 2 (entry of the driver's ID and name
and of the master code)
3.6.3
Driver 3
M
Driver Register 3 (entry of the driver's ID and name
and of the master code)
3.6.3
Driver 4
M
Driver Register 4 (entry of the driver's ID and name
and of the master code)
3.6.5
Driver 5
M
Driver Register 5, factory definition of master, can be
changed.
Driver Register (36n..)
No.
Name
Seal
K
Factory
Setting
Meaning
3.6.n.1
Driver ID
M
3
Personnel number of the driver
3.6.n.2
Driver Name
M
3
Name of the user, can be printed on receipts.
3.6.n.3
Master code
M
3
If not set to "0", then master code for increased
access.
"36n" is the driver's register number, with "n" varying from 1 to 6. For
unequivocal identification of a parameter the driver's register number is
extended by the parameter number.
Example: Driver's name in the third driver register
Driver Register
Parameter
36 3
2
The following operators are defined in the factory settings:
Employee ID.
Password
Access Right
000001
- - -
Driver
999999
654321
Master
* Passwords are always 6-digit numbers.