TechnipFMC Sening MultiFlow - Quick Start

Sening
®
is a registered trademark of FMC Technologies
21
MN F09 002 US  DOK-383E  Issue/Rev.3.65 (02/24)
MultiFlow  Quick Start
2 Quick Start
1. The main keys
 As a rule, the following functions are assigned to the below keys:
<Start> Start discharge
<Stop> a) Stop or terminate discharge
b) Quit an entry without saving the data
<Print> a) Switch to the report selection menu
b) Confirm and save entered values
<Enter> Go to the next possible entry
2. Discharge
This manual only regards operation of the MultiFlow. Of course, all other
conditions concerning the discharge of product have to be met as well.
 Switch on the MultiFlow.
 The MultiFlow runs a self-
test after which it is ready
for discharge.
 Press the <Start> key to
start the discharge.
 In case hose selection is
not available, pass on to
"Delivery preset" / p. 22.
FA Se ni ng MU LT IF L OW
S el ec t Pr od uc t a nd
Vo lu me w it h <S TAR T>
Pr in t Re po rt s
wi th <P RIN T>
Cu st om iz e Se tt ing s
wi th <F 3>
R ea dy
S el ft es t OK
S ea l OK
Ve rs io n5 .0 3[ 5. 13] UK
Sea l Lo ad M enu