To take up any slack in the ribbon, turn the feed knob on the left side
(TM-U295) or right side (DR-298) of the cassette in the direction of the
arrow shown on the cassette.
Remove the ribbon cassette by grasping the handle and pulling
straight out, until it is noticeably released.
Pull the cassette carefully towards you to release the ribbon from the
pressure rollers.
Now you can insert the new ribbon cassette in the printer.
Take care that the ribbon goes below the pressure rollers.
Push the cassette firmly until the pins in the back snap in.
To take up any slack in the new ribbon, turn the feed knob.
Close the cover.
The ribbon cassette can be purchased from F. A. Sening:
•
Epson TM-U295 : Part No. 7100031
• STAR DR-298(-FDW) : Part No. 7100157
6.7 Discharge operated remotely
The Sening MultiControl package includes a handheld controller with
which the MultiFlow can be remotely controlled (see also description in
the MultiControl operating manual).
Operation of the MultiFlow remains unaltered even when this remote
operation option is used. In addition there is however the opportunity after
the start of a discharge (see chapter 6.1 "Carrying Out a Discharge
(Part 1)" / page 71) to carry out the following operation steps remotely:
•
Correction of the pre-set volume in increments of 100 or 1000 with
simultaneous display on the handheld controller
•
Motor Start/Stop
•
Start of the discharge
•
Display of discharge volume or flow on the handheld controller
•
Control of motor speed during the discharge
•
Interruption and resumption of the discharge
•
Termination of the discharge
•
Emergency Cut-off
Control of motor speed is a remote operation option that can only be
implemented with vehicles fitted with electronic motor control. See the
description in the MultiControl operating manual.
To Next Page
Loading...
