TechnipFMC Sening MultiFlow - Chip Card; Program Update; Checksums; Sensor Monitor

MN F09 002 US  DOK-383E  Issue/Rev. 3.65 (02/24)
MultiFlow  Address and contact details
Sening
®
is a registered trademark of FMC Technologies
315
No.
Name
Seal
K
Factory
Setting
Meaning
4.4.2
Logbook
M/Cal.
(version 5.02 and higher)
Resets the internal logbook
Chip Card
No.
Name
Seal
K
Factory
Setting
Meaning
4.5
Chip card
4.5.1
Write Parameters
M/Cal.
Loads all parameters and delivery receipt definition
from the chip card.
4.5.2
Read Parameters
M/Cal.
Reads out all the parameters and the delivery
definition.
4.5.3
Format Chip
Cal.
Erases all data from a chip card.
Program Update
No.
Name
Seal
K
Factory
Setting
Meaning
4.6
Program update
(up to version 5.00)
4.6.1
Activated
M
Program update activated
4.6.2
Blocked
M
Program update barred
4.6
Program update
(up to version 5.00)
4.6.1
Program update
M
Enabling/disabling the download
4.6.2
Rem. download
attempts
M
Displays the remaining download attempts
4.6.3
Update report
M
Printout of download logbook
4.6.4
Reset
Cal.
Resetting the download logbook
Checksums
No.
Name
Seal
K
Factory
Setting
Meaning
4.7
Checksums
F
(version 5.00 and higher)
Display of all checksums and version number
Sensor Monitor
No.
Name
Seal
K
Factory
setting
Meaning
5
Logon
F
Entry of the driver code for a change of drivers
(logon).
6
Load Monitor
M
Displays the actual load status and gives the option to
set the warning level for "additive load undercut"
7
Flush measuring
system
F
Start of the flushing process for the measuring system
8
Residue removal
EPE2
F
Control of a residue discharge pump connected to the
EPE2. For this purpose the "EPE2-AIII" or "EPE2-AI"
mode must be activated (parameter 3.1.8.5.1).