TechnipFMC Sening MultiFlow - Office Transfer

Sening
®
is a registered trademark of FMC Technologies
235
MN F09 002 US  DOK-383E  Issue/Rev. 3.65 (02/24)
MultiFlow  Printing out Reports
Event
Data
Meaning
Memory Class 2
Seal break on account of a defective memory.
Memory Class 3
Seal break on account of a defective memory.
Drain Alarms:
Drain Meter
Activated
Connection MultiFlow <-> EPE2 connected
Deactivated
Residue removal monitoring via EPE2 deactivated
Link establ.
Connection MultiFlow <-> EPE2 re-connected
Link lost
Connection MultiFlow <-> EPE2 interrupted
PreCycle done
Residue removal monitoring via EPE2 activated and
complete residue removal cycle detected.
Finish->go on
Residue removal procedure completed before a
discharge
Drain started
Residue removal started
Drain complete
Residue removal ended
Auto-Started
Start of autom. residue removal via menu point 8
Auto-NoLink
Connection broken during autom. residue removal
Auto-ErrorStop
End of autom. residue removal because of a problem
Auto-TimeStop
End of autom. residue removal because the maximum
period for residue removal has been reached
Auto-UserStop
Autom. residue removal ended by the user
11->12 YES
Product changeover from 11 to 12, required residue
removal has been carried out.
11->12 NO
Product changeover from 11 to 12, required residue
removal suppressed by user input.
13->11 OK
Product changeover from 13 to 11, information
regarding prohibited residue removal has been
acknowledged by operator with OK.
IO module alarms:
Error
EIO NoRsp
EIO Intf.NoRsp
EIO IO NORsp
IO module does not answer.
Message informs about the internal status of the MFSI
control.
Error
EIO Interf: x
EIO Onl.Err: x
Module error detected.
01: CAN error
02: SW Watchdog
04: HW Watchdog
08: RAM error
10: ROM error
20: Reset State
11.8 Office transfer
It is possible to send delivery and event reports to the office interface
(e.g. FTP server) in combination with an EMIS connected to the external
CAN bus. This function is available only in connection with an EMIS!