☺ When all parameters have been successfully compared, the following
message appears:
"Data transfer complete!"
Acknowledge this message with <F1> ("OK").
☺ The procedure is now completed.
From software version 3.30[3.30] 1 x 16K chip card or 2 x 8K chip
cards are used.
9.13 Namur sensor interface - MFSI
Parts no.: MFSI
Drawing no.: 61.352182 / S. 350
Circuit diagram no.: 51.352198 / S.
351
Fig. 3: Namur Sensor interface - MFSI
The sensor interface (SI) allows you to connect up to 20 sensors. As with
the MultiSeal system the user can assign different sensor positions to
these sensors.
A simple sensor monitoring function is added to the MultiFlow when the
sensor interface is connected. The sensor interface monitors the
connected sensors irrespective of the connected operating voltage.
The following sensors are installed:
•
Sensors:
(RFID, MSDDST, MSDSO)
•
Sensors installed within the fittings:
(VKV1-I, VKV1M-I, VKV1PA-I, BO100-SPD, BO100-F1-SPD, BO100-
F2-SPD, DV100-4D, Manlid20-SPD)
To Next Page
Loading...
