TechnipFMC Sening MultiFlow - Parameter List

Sening
®
is a registered trademark of FMC Technologies
121
MN F09 002 US  DOK-383E  Issue/Rev. 3.65 (02/24)
MultiFlow  Configuration of the MultiFlow
9.3 Parameter List
The parameter menu contains several topics:
Device No., Operation Options, W&M
restrictions →
Transfer rate, FDW-Protocol →
Pulse Inputs, Temp. Sensor, Additive Pump →
Units, Price, Meter Factors →
For additional information on the tables refer to chapter 9.1 "Display
Configuration" / page 120 up to chapter 9.10 "Product Registers
(35nn..)" / page 166.
The complete table of parameters is listed in the annex "Parameter
summary".
• The column designated "No." gives the key combination with which
the parameter designated in the column "Name" is selected. If this
number is entered in the main menu via the keypad, the
corresponding parameter is called and displayed automatically.
• The column "Seal" gives the access rights and the function is
described in more detail in the column "Meaning".
There are five different categories of parameters:
K
Priority
Meaning
0
Cal.,
EEPROM
Highest security level;
device settings which are not saved on the parameter
chip
1
Cal.
High security level due to additional checksum;
parameter transfer from the chip card only possible
when seal is broken !
2
Master
High security level due to additional checksum;
parameter transfer from the chip card only possible
when seal is broken !
3
Master
Medium security level
x
Driver
Lowest security level; parameters which are not saved
on the chip card
P a ra me te r Li st
S el ec ti on : 3
1 De vi ce S et ti ngs
2 Pr in te r Se tt ing s
3 Se ns or s
4 Fo rm D es cr ip tio n
5 Pr od uc t Se tu p
6 D ri ve r Li st
Up Do wn ---