EasyManua.ls Logo

TechnipFMC Sening MultiFlow - Page 116

TechnipFMC Sening MultiFlow
356 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
122
Sening® is a registered trademark of FMC Technologies
MN F09 002 US  DOK-383E  Issue/Rev. 3.65 (02/24)
MultiFlow  Configuration of the MultiFlow
Example: After you have opened the main menu via key <F3> you select the
parameter "Billing" (chapter 9.3.1.4 "Operating options" / page 122)
with the key sequence <3> <1> <4> <0>. To change the setting master
access is required (see indication M).
An example of a parameter list is given in "Printout of Parameter List
(example)".
9.3.1 Device Settings
9.3.1.1
Device Number
9.3.1.2
Meter Designation
9.3.1.3
Seal Password
No.
Name
Seal
K
1
Factory
Setting
Meaning
3
Parameter List
3.1.1
Device Number
Cal.
1
-
This parameter should be assigned the device ID
(name-plate, see housing of operating device).
3.1.2
Meter Designation
Cal.
1
-
This parameter is used for identifying the measuring
system. The designation is printed on all delivery
notes and reports.
Recommendation:
Use the serial number of the measuring chamber
(name-plate).
3.1.3
Seal Password
Cal.
1
123456
Password protection for electronic W & M seal.
9.3.1.4
Operating options
No.
Name
Seal
K
Factory
Setting
Meaning
3.1.4
Operating Options
3
3.1.4.1
Operating Mode
M
3
0 (Standard)
Selection of operating mode:
1 Standard, support of single and multiple metering
systems
2 TMC mode, single and multiple metering systems
in conjunction with a TMC
3 OBC mode, single and multiple metering systems
in conjunction with an OBC
4 Like TMC mode, manual operation is
disabled (remote mode)
5 Like OBC mode, manual operation is
disabled (remote mode)
3.1.4.2
Save display
M
3
15
The discharged volume is saved in the display for the
selected time in minutes. Thereafter, the ready
screen is displayed again.
3.1.4.3
Currency Options
3
3.1.4.3.1
Applicable Currency
M
3
0
(Currency A)
Selection of applicable currency (A or B). All preset
prices, billing and driver input data are computed in
this currency.
Reference to the second currency can only be made
additionally at the end of the receipt/bill
(see EURO).
3.1.4.3 2
Exchange Rate
M
3
1.92573
Exchange rate between currencies A+B

Table of Contents

Related product manuals