Only the MultiFlow on which a program update is to be executed may
be “Activated". All others must be "Disabled". (menu 4.6.1)
To ensure the maximum number of available downloads, the download
logbook must be reset via menu item 4.6.4 before activation of the W &
M seal.
The currently active status is displayed (in double-sized font). Press any
key to exit the update mode.
The manual supplied with the service program contains detailed
instructions for loading a new program version via the printer line. See
chapter 15.2 "Software update by download" / page 275.
5.3 Initialization
After updating the software to a new version e.g. by loading the program
via the printer interface or by replacing the EPROM, the MultiFlow needs
to be re-initialized.
This means that the complete factory settings are re-established under
menu point 4 Initialization in the Service menu. Only data permanently
retained in the memory, such as the total sum readings or the serial
number, remain unaffected by the initialization.
To avoid the time-consuming job of entering the parameters manually,
you can simply load these into the MultiFlow from a chip card (see
chapter 9.12 "Saving Parameters on the Chip Card" / page 172).
5.4 Chip Card Reader
The chip card reader is integrated into the upper part of the MultiFlow.
Only the chip cards supplied by F. A. Sening should be used.
If chip cards from other suppliers are used, then faults in operation may
occur.
The slot for the chip card is located behind the plastic flap on the side of
the device where it is protected from contamination. In the latched state,
the chip card reader conforms to IP65 class of protection.
To Next Page
Loading...
