MN F09 002 US DOK-383E Issue/Rev. 3.65 (02/24)
Sening
®
is a registered trademark of FMC Technologies
You can deactivate the alarm by setting the minimum volume to zero.
6.10 Product Transfer / Self Loading
Since version 3.15 the MultiFlow offers the option of recording and
logging product transfer resp. self loading to compartments of a tank
truck. Doing this, the path selection (parameter 3.1.8.1, chapter 9.3.1.8
"Valve Control" / page 145) has to be set to control type no. 5.
Product Transfer or Self Loading is indicated to the MultiFlow by
activating the MultiFlow input S4 before entering a preset for the
discharge. Usually, the Input S4 is connected to an interlock of the filling
couplings.
To distinguish Product Transfer and Self Loading, the selected hose is
considered:
Normal delivery via wet hose
Normal delivery via dry hose
Product Transfer via wet hose
Self loading via dry hose
The following points have to be taken under consideration for Product
Transfer / Self Loading:
•
It is impossible to select and deliver additivated products.
•
After carrying out a Product Transfer / Self Loading, no further
products can be added to the batch; the receipt will be printed
immediately.
•
If form element No. 20 is used, receipts will automatically have a
corresponding head line (chapter 10.1.3 " Summary of Text Modules
" / page 200).
•
Receipts for Product Transfer / Self Loading may include an additional
text which states that this receipt is only for internal use and may not
be used for trading:
Only for internal use,
Not Authorized for Trade Use !
This text is stored in the new form element No. 31 (chapter 10.1.3 "
Summary of Text Modules " / page 200).
Product Transfer means a product is pumped from one compartment of
a tank truck into another of the same truck. Possible applications are:
To Next Page
Loading...
