TechnipFMC Sening MultiFlow - Emergency Power Supply - Battery Change - MF-EPS

MN F09 002 US  DOK-383E  Issue/Rev. 3.65 (02/24)
MultiFlow  Discharge
92
Sening® is a registered trademark of FMC Technologies
6.12 Emergency power supply – Battery change -
MF-EPS
MultiFlow Emergency power supply - MF-EPS
Figure 2: MF-EPS
Tools
1. Screwdriver 3.5 mm
2. Cross tip screwdriver
Insert batteries
5
Press the battery into the
holder.
1 2 3
Package contents MF-EPS Open the emergency power Insert the batteries and
supply. carefully push them into the
clamps at a sloping angle.
Polarity!
4
Ensure correct polarity!
6
Insert the batteries
diagonally from above.
Polarity!