Sening® is a registered trademark of FMC Technologies
MN F09 002 US DOK-383E Issue/Rev. 3.65 (02/24)
MultiFlow Printing out Reports
No flow has been measured for an extended period of
time.
A parameter lies outside the range of values valid for
the parameter (parameter conflict).
The seal has been broken.
An error in the Multi-IO sensor has been detected.
Setup: A parameter was changed
3161: The changed parameter
Global node no.: Parameter name
1: The new parameter value
Drop:
(??)
Heating Oil EL:
1250 L
A delivery was performed
The device was not sealed
Product code
Discharged quantity
Drop:
(OK)
Heating Oil EL:
1250 L
A delivery was performed
The device was sealed
Product code
Discharged quantity
PT:
(??)
Heating Oil EL:
1250 L
A product transfer was performed
The device was not sealed
Product code
Transferred quantity
PT:
(OK)
Heating Oil EL:
1250 L
A product transfer was performed
The device was sealed
Product code
Transferred quantity
SL:
(??)
Heating Oil EL:
1250 L
A self-loading was performed
The device was not sealed
Product code
Loaded quantity
SL:
(OK)
Heating Oil EL:
1250 L
A self-loading was performed
The device was sealed
Product code
Loaded quantity
The logbook contains one or more invalid entries.
A short report has been printed.
A detailed report has been printed.
A report chip has been generated.
The hardware seal has been broken.
Seal break on account of a defective checksum.
Seal break on account of a defective setup of meter.
Seal break on account of a defective memory.
To Next Page
Loading...
