TechnipFMC Sening MultiFlow - Page 258

262
Sening® is a registered trademark of FMC Technologies
MN F09 002 US  DOK-383E  Issue/Rev. 3.65 (02/24)
MultiFlow  Miscellaneous Information
ALT
ALT
- Baud rate: <9600>,
- Parity: <EVEN>
- Data bits: <8Bit>.
 These parameters may be printed out as follows:
Press the POWER/SLEEP key and immediately afterwards press the
(Alt) key. If you wish to make changes to the setting of these
parameters please consult the following chapters.
14.7.2 Changing the parity in the “INSTALL” Setup mode
Activate Setup mode
 Press the
key for one second (Power on) and
immediately afterwards press the READY/CLEAR (SETUP/EXIT) key for
one second.
Insert paper (automatic paper feed)
 Insert the paper again afterwards,
 Printing starts automatically.
 Five lines (up to line “SETUP/EXIT”) will need to be printed.
Please compare the sample print-out (1) below.
 In the next section, print up to line “FUNKTIONS” and “MACRO”.
Please compare the sample print-out (2) below.
Sample print-out
Choose the “INSTALL” function
 After the print-out, press the LOAD/FF (NEXT) key to access the
“INSTALL” selection in Setup mode.
 Press the + (NEXT) key to select the “INSTALL” function.
Press the 6 x
out.
(NEXT) key six times until “PARITY” is printed
POWER/SLEEP
LOAD/FF
LOAD/FF