1.
After entering all the preset
values and pressing the
<START> key again, the
MultiFlow checks whether a
product change has taken
place between diesel and
heating oil / heating oil with
additives. If this has
happened a corresponding
message is shown about
the necessary residue
removal:
2.
If residue removal has not
been carried out the driver
must press the <F2> key. A
corresponding entry is then
made in the logbook and
the display shows the
following information:
•
The MultiFlow remains in
this operating state until it is
switched off, i.e. it will not
react to key entries (e.g.
<START>, <STOP> etc.).
3.
After carrying out the residue removal operation (for this period the
MultiFlow is switched off by the residue removal controller) the
MultiFlow starts up again and the driver must repeat the discharge
pre-set entries. The query as to whether residue removal has been
carried out is this time confirmed by pressing the <F1> key. The
confirmation is saved in the logbook.
After carrying out residue removal you should continue with the 4
th
part of
the discharge procedure (see chapter 6.4 "Electronic hose selection
(optional)" / page 78).
6.3.2
MultiFlow from version 5.00
The following description is relevant only for program versions 5.00 and
higher (approval according to MID).
To Next Page
Loading...
