Finally, the tax rate must be defined.
Here the tax rate applicable to the product is entered.
Confirm the entered tax rate by pressing <Print>.
Disregard point 7 Temp. compensation. This option is only active for
liquid products discharged through the flow meter.
7.2.3
Defining the Additive Use
In addition to the additive definition, the use of the additive must be
entered for the measured product.
+
To select the product, go to Product Page 3.5.
Example: The product "Heating oil" is to be dispensed. The general parameters
have already been defined as the ninth entry on the first product page.
Select Product Page 1 with key <1>.
Select "Heating oil +" by pressing the corresponding key (<9>) or by
using key <F1> "Up" or <F2> "Down" and <Enter>.
Call up the additive dispensing parameters with key <5>.
Here, the additive dispensing can be activated under point <1>.
Set this entry to <1> "Yes".
Call up the additive selection with key <2>. Here the product register
number for the desired additive is inserted.
Example: "Burny" on Product Page 2 at position 2 would have the register number
22. When discharging "Heating oil +", the additive "Burny" would now
be automatically mixed at a ratio of 1/2000.
The additive options are left with <Stop>.
The next step is to define the default price. You enter the price by
pressing keys <6> and <1>.
The price is accepted into the MultiFlow with <Print>.
Take note of parameter 3.1.4.0 for differentiating between net and
gross! The price of the product including additive (for injection before
the measuring system) must include the additive price.
The price factor indicates the quantity factor.
To Next Page
Loading...
