TechnipFMC Sening MultiFlow - Page 156

162
Sening® is a registered trademark of FMC Technologies
MN F09 002 US  DOK-383E  Issue/Rev. 3.65 (02/24)
MultiFlow  Configuration of the MultiFlow
9.4.4 Initialize
No.
Name
Seal
K
Factory
Setting
Meaning
4.4
Initialize
M/Cal.
Resets the device parameters (restores the
factory settings).
4.4.1
Device Parameter
M/Cal.
(version 5.02 and higher)
Resets the device parameters
4.4.2
Logbook
M/Cal.
(version 5.02 and higher)
Resets the internal logbook
9.4.5 Chip card
No.
Name
Seal
K
Factory
Setting
Meaning
4.5
Chip card
4.5.1
Write Parameters
M/Cal.
Loads all parameters and delivery receipt definition
from the chip card.
4.5.2
Read Parameters
M/Cal.
Reads out all the parameters and the delivery
definition.
4.5.3
Format Chip
Cal.
Erases all data from a chip card.
9.4.6 Program update
No.
Name
Seal
K
Factory
Setting
Meaning
4.6
Program update
(up to version 5.00)
4.6.1
Activated
M
Program update activated
4.6.2
Blocked
M
Program update barred
4.6
Program update
(up to version 5.00)
4.6.1
Program update
M
Enabling/disabling the download
4.6.2
Rem. download
attempts
M
Displays the remaining download attempts
4.6.3
Update report
M
Printout of download logbook
4.6.4
Reset
Cal.
Resetting the download logbook
9.4.7 Checksums
No.
Name
Seal
K
Factory
Setting
Meaning
4.7
Checksums
F
(version 5.00 and higher)
Display of all checksums and version number
 The following description is relevant only for program versions 5.00 and
higher (approval according to MID).