transferred, the message:
"Data transfer successful!" appears.
The last event in the report time-period is saved by the MultiFlow and is
used during the next data transfer for determining the default setting for
the required extent of the report.
Now you can take the chip card out of the MultiFlow and the data can
be processed by a suitable EDP system. Manual data acquisition with
its attendant transfer errors is no longer needed. See 57.
11.1.1.2
Large Quantities of Data
If the gathered report data exceeds the capacity of one chip card, the
remaining data can be transferred to a second card, and so on. In this
case the following message appears after the data transfer:
„Chip card full! Please insert next chip card“
Change the chip card.
Then acknowledge the message with <F1> “OK”.
☺ The transfer is continued.
To avoid data losses, it is essential to change the chip card before
acknowledging the message!
11.2 Short Report
The reports made available differ in the length of the printout and thus in
their information content. With the short report only the most important
data in compressed form is printed out.
To Next Page
Loading...
