TechnipFMC Sening MultiFlow - Page 233

Sening
®
is a registered trademark of FMC Technologies
237
MN F09 002 US  DOK-383E  Issue/Rev. 3.65 (02/24)
MultiFlow  Printing out Reports
Office transfer menu
☺ The choice is between delivery
and event data.
☺ Depending on the selection the
operator can limit the scope of
the report by specifying the
range of receipt numbers
(delivery data only) or by
limiting the period of time.
 If data is available in the
specified receipt/time frame,
the transfer begins. The data is
initially transferred to the EMIS.
Once this transfer is complete, the data is sent from the EMIS via
GSM/GPRS to the office interface.
 The MultiFlow displays different status screens depending on the transfer
phase via which the operator is informed about the current transfer
status.
Delivery data / MultiFlow -> EMIS
In the case of a local data transfer from the MultiFlow to the EMIS the
current transfer progress is displayed in percent.
 The transfer to the EMIS can
be interrupted by pressing the
<STOP> key.
☺ Once all data has been
transferred to the EMIS the
following status screen is
displayed for the external data
transfer.
Off ic e tr an sf er
Se le ct io n: 72
1 D el iv er y dat a
2 Ev en t da ta
3 Se ns or üb er wa chu ng
For wa rd Ba ck -- -
Del iv er y da ta
D at a tr an sm i ssi on
Mu lt iF lo w - > EMI S
P le as e
wa it
5 0%
- --
-- -
-- -