TechnipFMC Sening MultiFlow - Page 281

Sening
®
is a registered trademark of FMC Technologies
285
MN F09 002 US  DOK-383E  Issue/Rev. 3.65 (02/24)
MultiFlow  Software update
 Re-assemble the devices (grease threads!).
 Switch on and initialize MultiFlow (parameter 4.4).
 Read out parameter from chip card (parameter 4.5.1).
 Check receipt ID (parameter 3.1.9).
 Print and compare parameter list.
 Print and compare delivery note.
 Set and print out W&M seal.