ELECTRICAL
4181383 First Edition 4-59
4
Raise/Lower Switch Test
See Figure 4-26.
1. Park the mower safely. (See “Park Mower Safely” on
page 1-5.)
2. Remove the raise-lower switch from the instrument
panel. (See “Raise/Lower Switch” on page 4-74.)
Figure 4-26
3. Connect test leads to terminals (2 and 3) and check
for continuity.
Is continuity indicated?
YES The switch is faulty; replace the raise-lower
switch assembly.
NO Proceed to step 4.
4. With the test leads connected as described in step 3,
move and hold the raise-lower lever in the lower
position.
5. Check for continuity.
Is continuity indicated?
YES Proceed to step 6.
NO The switch is faulty; replace the raise-lower
switch assembly.
6. Return the raise-lower lever to the center (neutral)
position.
7. Connect test leads to terminals (4 and 5) and check
for continuity.
Is continuity indicated?
YES The switch is faulty; replace the raise-lower
switch assembly.
NO Proceed to step 8.
8. With the test leads connected as described in step 7,
move and hold the raise-lower lever in the raise
position.
Is continuity indicated?
YES The raise-lower switch assembly is good.
NO The switch is faulty; replace the raise-lower
switch assembly.
Required Tools or Equipment
Digital Multimeter, Ohmmeter, or Continuity Tester
3
2
5
4
TN1098