EasyManuals Logo

Textron Jacobsen AR-5 Technical/Repair Manual

Textron Jacobsen AR-5
295 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #134 background imageLoading...
Page #134 background image
5-6 4181383 First Edition
HYDROSTATIC POWER TRAIN
5
Traction Circuit Reverse Schematic
and Theory of Operation
See Figure 5-4.
System Conditions:
Engine running
Park brake released
Traction pedal depressed (reverse position)
Charge Pressure Circuit
The charge pump and traction pump are both driven by
the engine. The charge pump is mounted between the
rotating group and rear valve plate assembly in the
traction pump housing. It supplies oil to the traction
pump/circuit. Oil is drawn from the hydraulic tank,
through a 100 mesh screen, and enters the charge
pump. Oil is then routed to the charge pressure relief
valve, the traction pump, and the displacement control
valve. The charge pressure relief valve regulates the
charge pressure applied to the traction pump/circuit.
When the incoming charge pressure oil reaches 285 psi
(20 bar), the charge pressure relief valve will open,
venting excess flow to the hydraulic tank.
Traction Pump Circuit
When the traction pedal is moved to the reverse position,
the displacement control valve is moved to the reverse
position. Charge oil is supplied through 0.28” orifice,
displacement control valve, and to the traction pump,
moving the swash plate, stroking the pump, and
producing oil flow to port “B.” Operating pressure oil from
port “B” of the traction pump is supplied in parallel to the
rear wheel motors and in series to the front wheel
motors. Oil from the rear wheel motors returns to the
traction pump, entering through port “A.” The 0.28” orifice
meters the amount of oil to servo piston which dampens
the flow of oil, reducing the chance of wheel spin. The
0.31” orifice dampens the flow of oil to tank. The traction
circuit is protected by a circuit relief valve. This valve will
open, venting excess oil flow to the return side of loop.
when the pressure rises above 3625 psi (250 bar).
Hot Oil Shuttle
The hot oil shuttle is located in the 4WD valve. The hot oil
shuttle is held closed when there is operating pressure in
the reverse direction.

Table of Contents

Other manuals for Textron Jacobsen AR-5

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Textron Jacobsen AR-5 and is the answer not in the manual?

Textron Jacobsen AR-5 Specifications

General IconGeneral
BrandTextron
ModelJacobsen AR-5
CategoryLawn Mower
LanguageEnglish

Related product manuals