THOMSON Amethyst III - Page 253

Appendix B ’SNMP Management’ — Getting the Switch State
Amethyst III DTV Smart Switch 253
User Manual
2. In the commXmlParCommandBufferValue.0 leaf, write the string
corresponding to the command:
SET commXmlParCommandBufferValue.0 (octet string)
"<GetSwitchStates/>"
Walk the table to see the response. You should get a string like the
following:
***** SNMP QUERY STARTED *****
1: commXmlRespContBufferId.0.0 (gauge) 0
2: commXmlRespContBufferIndex.0.0 (gauge) 0
3: commXmlRespContCommandType.0.0 (integer) 7
4: commXmlRespContBufferValue.0.0 (octet string)
<?xml version="1.0" encoding="UTF-8" standalone="no"?>
<SwitchesStates>
<InputsList>
<Input Id="5001" Name="input 1" ElementIdName="TS 
overIP Input 1" Status="OK"/>
<Input Id="5002" Name="input 2" ElementIdName="TS 
over IP Input 2" Status="OK"/>
<Input Id="5003" Name="input 3" ElementIdName="TS 
over IP Input 3" Status="OK"/>
<Input Id="5004" Name="input 4" ElementIdName="TS 
over IP Input 4" Status="CRITICAL"/>
</InputsList>
<SwitchesList>
<Switch Id="9001" Name="switch 1" ElementIdName="IP 
Switch 1" Status="OK" Strategy="redundancy">
<InputRef IdRef="5001"/>
<ActiveInputRef IdRef="5002"/>
</Switch>
<Switch Id="9002" Name="switch 2" ElementIdName="IP 
Switch 2" Status="WARNING" Strategy="redundancy">
<ActiveInputRef IdRef="5003"/>
<InputRef IdRef="5004"/>
</Switch>
</SwitchesList>
<SwitchesAssociationsList/>
<OutputsList>
<Output Id="400001" IdRef="9001" Name="output 1" 
ElementIdName="TS over IP Output 1" IsInverse="false"
IsMonitoring="false" Status="OK">
<ActiveEthernetRef IdRef="11002" IsMain="true"/>
</Output>
<Output Id="400002" IdRef="9002" Name="output 2" 
ElementIdName="TS over IP Output 2" IsInverse="false" 
IsMonitoring="false" Status="OK">
<ActiveEthernetRef IdRef="11002" IsMain="true"/>
</Output>
<Output Id="400003" IdRef="9001" Name="output 3" 
ElementIdName="TS over IP Output 3" IsInverse="false" 
IsMonitoring="false" Status="OK">