THOMSON TG605s - Eth Commands

eth Commands
E-DOC-CTC-20080409-0002 v2.0
261
eth Commands
eth bridge add Add a new bridge instance. see page 266
eth bridge clear Clear bridge statistics. see page 267
eth bridge config Modify/Display the bridge
configuration settings.
see page 268
eth bridge delete Delete a bridge instance. see page 269
eth bridge dynvlan actlist Display the active MAC entries for the
dynamic VLAN membership.
see page 270
eth bridge dynvlan add Add a dynamic VLAN membership
entry.
see page 271
eth bridge dynvlan config Modify the dynamic VLAN
membership configuration.
see page 272
eth bridge dynvlan delete Delete a dynamic VLAN membership
entry.
see page 273
eth bridge dynvlan flush Flush all dynamic VLAN membership
entries.
see page 274
eth bridge dynvlan list Display a dynamic VLAN membership
entry.
see page 275
eth bridge filter add Add a filter. see page 276
eth bridge filter attach Enable a filter. see page 277
eth bridge filter config Change filter configuration see page 278
eth bridge filter delete Delete a filter. see page 279
eth bridge filter detach Disable a filter. see page 280
eth bridge filter forwarding Action: set forwarding configuration. see page 281
eth bridge filter fwdintfadd Add Forwarding interface: filter
action.
see page 282
eth bridge filter fwdintfdel Remove Forwarding interface: filter
action.
see page 283
eth bridge filter ifadd Connect an interface with a filter. see page 284
eth bridge filter ifdel Remove an interface from a filter. see page 285
eth bridge filter list Display the bridge filters. see page 286
eth bridge flush Flush all bridge instances with their
interfaces and properties.
see page 287
eth bridge ifadd Add a new bridge interface. see page 288