THOMSON TG605s - Eth Switch Shaper Config

eth Commands
E-DOC-CTC-20080409-0002 v2.0
377
eth switch shaper config
Configure common ingress shaper parameters.
SYNTAX:
eth switch shaper config shaper = <number{0-1}>
[unicast = <{enabled|disabled}>]
[multicast = <{enabled|disabled}>]
[broadcast = <{enabled|disabled}>]
[control = <{enabled|disabled}>]
[unknown = <{enabled|disabled}>]
[discard = <{enabled|disabled}>]
where:
shaper The shaper instance. REQUIRED
unicast Shape unicast traffic. OPTIONAL
multicast Shape multicast traffic. OPTIONAL
broadcast Shape broadcast traffic. OPTIONAL
control Shape MAC control traffic. OPTIONAL
unknown Shape traffic with unknown destination address. OPTIONAL
discard Discard frame at overflow (else attempt for flow
control).
OPTIONAL