ipqos Commands
E-DOC-CTC-20080409-0002 v2.0
541
ipqos meter config
Modify an IP QoS meter configuration.
SYNTAX:
ipqos meter config name = <{}>
[label = <{DSCP|Interactive|Management|Video|
VoIP-RTP|VoIP-Signal|default}>]
[intf = <{loop|ipsec0|lan1|wan1|dmz1|guest1}>]
[droprate = <number{0-102400}>]
[markrate = <number{0-102400}>]
[burst = <number{0-64}>]
[dropaction = <{count|drop}>]
[markaction = <{count|mark}>]
[tosmarking = <{disabled|enabled}>]
[tos = <number{0-255}>]
[dscp = <{ef|af11|af12|af13|af21|af22|af23|
af31|af32|af33|af41|af42|af43|cs0|cs1|cs2|cs3|
cs4|cs5|cs6|cs7} or number>]
[precedence = <{routine|priority|immediate|
flash|flash-override|CRITIC-ECP|internetwork-
control|network-control} or number>]
[classification = <{decrease|overwrite|ignore|
offset}>]
[class = <number{0-15}>]
where:
name The name of the IP QoS meter. REQUIRED
label The name of the label. OPTIONAL
intf The name of the interface. OPTIONAL
droprate The drop rate in kilo bits per second (Kbps). OPTIONAL
markrate The mark rate in kilo bits per second (Kbps). OPTIONAL
burst The burst size in kilo bytes (KB). OPTIONAL
dropaction The drop action. OPTIONAL
markaction The mark action. OPTIONAL
tosmarking Enable tos marking for marked packets. OPTIONAL
tos The type of service used for tos marking. OPTIONAL
dscp The diffserv code point (part of tos, used for tos-
marking).
OPTIONAL
precedence The precedence (part of tos, used for tos-
marking).
OPTIONAL