THOMSON TG605s - Eth Switch Storm Ifconfig

eth Commands
E-DOC-CTC-20080409-0002 v2.0
383
eth switch storm ifconfig
Configure per port storm control parameters.
SYNTAX:
eth switch storm ifconfig port = <number{1-4}>
[state = <{enabled|disabled}>]
[rate = <{33|50|100|200}>]
[burstsize = <number{2-8}>]
[broadcast = <{enabled|disabled}>]
[multicast = <{enabled|disabled}>]
[unknown = <{enabled|disabled}>]
where:
port The port. REQUIRED
state Enable/disable storm control. OPTIONAL
rate Rate in 10ths of percent. OPTIONAL
burstsize Burst size in KBytes. OPTIONAL
broadcast Storm control for broadcast traffic. OPTIONAL
multicast Storm control for multicast traffic. OPTIONAL
unknown Storm control for traffic with unknown
destination address.
OPTIONAL