THOMSON TG605s - Ipsec Peer Options Modify

ipsec Commands
602
E-DOC-CTC-20080409-0002 v2.0
ipsec peer options modify
Changes a peer options group.
SYNTAX:
ipsec peer options modify name = <>
[localaddr = <ip-address>]
[nat-t = <{enabled|disabled}>]
[dpd = <{disabled|enabled}>]
[dpd_idle_period = <number{10-3600}>]
[dpd_xmits = <number{1-5}>]
[dpd_timeout = <number{5-120}>]
[inactivity = <number>]
[nat-t_keepalive = <number>]
where:
name The name of the peer options group to change. REQUIRED
localaddr Selected black IP address of the local IPSEC
gateway
OPTIONAL
nat-t NAT Traversal support. OPTIONAL
dpd Enable/Disable the Death Peer Detection
support.
OPTIONAL
dpd_idle_period The number of seconds before the remote peer
is considered idle.
OPTIONAL
dpd_xmits The maximum number of Death Peer Detection
R_U_THERE messages before the remote peer is
considered as death.
OPTIONAL
dpd_timeout Number of seconds between retries if the Death
Peer Detection R_U_THERE message fails.
OPTIONAL
inactivity Inactivity timeout (seconds). OPTIONAL
nat-t_keepalive nat traversal keepalive interval (seconds). OPTIONAL