THOMSON TG605s - Grp Rip Config

grp Commands
E-DOC-CTC-20080409-0002 v2.0
437
grp rip config
Set the RIP configuration settings.
SYNTAX:
grp rip config state = <{disabled|enabled}>
[version = <{rip_unspec|rip_v1|rip_v2}>]
[defmetric = <number{1-16}>]
[updatetime = <number{1-3600}>]
[timeouttime = <number{1-3600}>]
[garbagetime = <number{1-3600}>]
[impcrt = <{disabled|enabled}>]
[impkrt = <{disabled|enabled}>]
[impdefkrt = <{disabled|enabled}>]
[exprt = <{disabled|enabled}>]
[expdefrt = <{disabled|enabled}>]
[txdefrt = <{disabled|enabled}>]
[trace = <{disabled|enabled}>]
where:
state Enable/Disable the RIP daemon. REQUIRED
version Set the RIP version. OPTIONAL
defmetric Set the default RIP metric (1-16) for imported
routes. Default metric value is 1.
OPTIONAL
updatetime Set the routing table update timer value. Default
is 30 seconds.
OPTIONAL
timeouttime Set the routing info timeout timer value. Default
is 180 seconds.
OPTIONAL
garbagetime Set the garbage collection timer value. Default is
120 seconds.
OPTIONAL
impcrt Enable/Disable the import of connected routes. OPTIONAL
impkrt Enable/Disable the import of kernel routes. OPTIONAL
impdefkrt Enable/Disable the import of the default kernel
route.
OPTIONAL
exprt Enable/Disable the export of received RIP routes. OPTIONAL
expdefrt Enable/Disable the export of the received RIP
default route.
OPTIONAL
txdefrt Enable/Disable the transmission of the default
RIP route.
OPTIONAL
trace Enable/Disable tracing. OPTIONAL