THOMSON TG605s - Xdsl Commands

xdsl Commands
E-DOC-CTC-20080409-0002 v2.0
945
xdsl Commands
xdsl add Add a wire-pair to a DSL-interface. see page 947
xdsl debug atmstats Display ATM statistics. see page 948
xdsl debug clear Clear statistics. see page 949
xdsl debug efmlinestats Display IEEE 802.3-Clause30 Statistics
(Line Side).
see page 950
xdsl debug efmsystemstats Display IEEE 802.3-Clause30 Statistics
(System Side).
see page 951
xdsl debug info Display DSL line & device
information.
see page 952
xdsl debug lloopback Configure Local Loopback (applies to
CPE mode only).
see page 953
xdsl debug pafstats Display PAF statistics. see page 954
xdsl debug pmdlinestats Display PMD statistics (line side). see page 955
xdsl debug pmdsystemstats Display PMD statistics (system side). see page 956
xdsl debug rloopback Configure Remote Loopback (applies
to CO mode only).
see page 957
xdsl debug showmdioreg Show the value of a MDIO register by
name.
see page 958
xdsl debug traceconfig Set the trace level. see page 959
xdsl delete Delete a wire-pair from a DSL-
interface.
see page 960
xdsl ifadd Create a DSL-interface. see page 961
xdsl ifattach Activate a DSL-interface. see page 962
xdsl ifconfig Configure a DSL-interface. see page 963
xdsl ifdelete Delete a DSL-interface. see page 964
xdsl ifdetach de-Activate a DSL-interface. see page 965
xdsl iflist List all DSL-interfaces. see page 966
xdsl list List all wire-pairs and their
assignment.
see page 967
xdsl profile add Add a DSL-interface profile. see page 968
xdsl profile delete Delete a DSL-interface profile. see page 969
xdsl profile list Display a DSL-interface profile. see page 970