THOMSON TG605s - Eth Switch Shaper Ifconfig

eth Commands
378
E-DOC-CTC-20080409-0002 v2.0
eth switch shaper ifconfig
Configure per port shaper parameters.
SYNTAX:
eth switch shaper ifconfig port = <number{1-4}>
ingress = <{enabled|disabled}>
shaper = <number{0-1}>
[state = <{enabled|disabled}>]
[speed = <number{64000-100000000}>]
[burstsize = <{6|10|18|34|66|126}>]
where:
port The port. REQUIRED
ingress Ingress port = enabled; egress port = disabled. REQUIRED
shaper The shaper instance. REQUIRED
state Enable/disable shaping. OPTIONAL
speed Speed in bits/sec. OPTIONAL
burstsize Burst size in KBytes. OPTIONAL