autopvc Commands
86
E-DOC-CTC-20080409-0002 v2.0
autopvc config
Configure autopvc.
SYNTAX:
autopvc config [mode = <{pseudo|passive|active}>]
[type = <{bridge|pppoerelay|ipoa|ethoa|pppoa|
pppoe}>]
[overwrite = <{disabled|enabled}>]
[peakrate = <number{0-27786}>]
where:
mode Autopvc mode. OPTIONAL
type Type of autopvc. OPTIONAL
overwrite Enable/disable UBR peak rate overwrite. OPTIONAL
peakrate The UBR peak rate (in kilobits per second) '0' to
indicate linerate.
OPTIONAL
To Next Page
Loading...
