THOMSON TG605s - Eth Bridge Dynvlan Add

eth Commands
E-DOC-CTC-20080409-0002 v2.0
271
eth bridge dynvlan add
Add a dynamic VLAN membership entry.
SYNTAX:
eth bridge dynvlan add [id = <number{0-100000}>]
hwaddr = <masked-hardware-address>
vlan = <{default|wan|dmz|guest}>
[remvlan = <{default|wan|dmz|guest}>]
where:
id The id of the dynamic VLAN membership entry. OPTIONAL
hwaddr The (masked) ethernet MAC address of the
dynamic VLAN membership entry.
REQUIRED
vlan The VLAN for the dynamic VLAN membership
entry.
REQUIRED
remvlan The VLAN that will be removed from the bridge
interface.
OPTIONAL