THOMSON TG605s - Ipsec Peer Modify

ipsec Commands
598
E-DOC-CTC-20080409-0002 v2.0
ipsec peer modify
Changes a peer gateway profile.
SYNTAX:
ipsec peer modify name = <>
[remoteaddr = <IP address or hostname>]
[backupaddr = <IP address or hostname>]
[exchmode = <{main|aggressive}>]
[localid = <Identity : format(type)value; type
being >]
[remoteid = <Identity : format(type)value;
type being >]
[phyif = <{lan1|wan1|dmz1|guest1|any}>]
[descr = <{AES_SHA1|AES_MD5|3DES_SHA1|
3DES_MD5|DES_SHA1|DES_MD5|AES_SHA1_Adv|
3DES_SHA1_Adv}>]
[auth = <>]
[options = <>]
where:
name The name of the peer profile to change. REQUIRED
remoteaddr Black IP address/hostname of the peer IPSEC
gateway.
OPTIONAL
backupaddr Black IP address/hostname of the redundant
peer IPSEC gateway.
OPTIONAL
exchmode Authenticated key exchange mode. OPTIONAL
localid The ID by which the peer gate identifies this
gate.
OPTIONAL
remoteid The ID of the peer gate. OPTIONAL
phyif Interface this peer applies to. OPTIONAL
descr Up to 4 phase one (ISAKMP) security descriptors
separated by |
OPTIONAL
auth Authentication attribute. OPTIONAL
options Peer options. OPTIONAL