xdsl Commands
E-DOC-CTC-20080409-0002 v2.0
963
xdsl ifconfig
Configure a DSL-interface.
SYNTAX:
xdsl ifconfig name = <DSL-interface>
[ul-mode = <{atm|efm|auto}>]
[wire-mode = <{auto|1pair|2pair|3pair|4pair}>]
[int-channel = <DSL-channel>]
where:
name The name of a DSL-interface. REQUIRED
ul-mode The DSL upper layer protocol: Asynchronous
Transfer Mode (ATM) or Ethernet in the First Mile
(EFM).
OPTIONAL
wire-mode The device's DSL wire configuration: 1-pair, 2-
pair.
OPTIONAL
int-channel The internal communication channel: none or
dsl0.
OPTIONAL
To Next Page
Loading...
