THOMSON TG605s - Grp Rip Ifconfig

grp Commands
E-DOC-CTC-20080409-0002 v2.0
439
grp rip ifconfig
Configure a RIP interface.
SYNTAX:
grp rip ifconfig intf = <{guest1|dmz1|wan1|lan1|ipsec0}>
[rip = <{disabled|enabled}>]
[txversion = <{rip_unspec|rip_v1|rip_v2|
rip_v1-2}>]
[rxversion = <{rip_unspec|rip_v1|rip_v2|
rip_v1-2}>]
[authmode = <{none|cleartext}>]
[authstr = <password>]
[passive = <{disabled|enabled}>]
[splithorizon = <{disabled|enabled}>]
where:
intf The name of the RIP interface to configure. REQUIRED
rip Enable/Disable the RIP status. OPTIONAL
txversion Set the RIP transmit version. OPTIONAL
rxversion Set the RIP receive version. OPTIONAL
authmode Set the RIP authentication mode. OPTIONAL
authstr Set the RIP authentication password. OPTIONAL
passive Enable/Disable the passive interface status. OPTIONAL
splithorizon Enable/Disable the split horizon status. OPTIONAL